Orlando, FL 32821 (407) 269-0453

Dundee Garage Door Sensor Repair

Free Dundee Garage Door Sensor Repair Estimate

Tell us what your door is doing and we will come out to Dundee, check the whole system and give you one flat price for your sensor repair before any work starts.

  • Same-day and 24/7 emergency service
  • Two-hour arrival windows, not all-day waits
  • Flat-rate pricing approved before we start
  • Licensed and insured technicians

Call now(407) 269-0453

Request your free estimate

Serving Dundee and all of Polk County, 7 days a week.

AC Garage Door Free Estimate

A blinking opener light and a door that will not close usually point to the safety sensors. In Dundee, we see sensors knocked loose by bikes and trash cans, wires chewed or corroded, and lenses fogged by humidity. We find the actual cause and fix it, often in a single visit.

Dundee is in Polk County, between Orlando and Tampa. Most of the homes we service in Dundee were built in the last 20 to 35 years, so original springs and openers are reaching the end of their life. AC Garage Door Repair works in Dundee every week, and we know the door styles, builders and problems that are common here. Every job comes with a flat-rate price you approve first, a two-hour arrival window, and a technician who explains what failed and why. If you also need Dundee Garage Door Repair for something else on the door, we handle it on the same visit.

Signs You Need Garage Door Sensor Repair in Dundee

  • Wires along the wall are damaged, stapled through or corroded
  • The opener light blinks and the door will not close
  • One sensor’s indicator light is off or flickering
  • Sensor brackets are bent or have been knocked loose
  • The sensor lenses are dirty, fogged or in direct sunlight
  • The door only closes when you hold the wall button down

If you notice any of these, stop using the door if it seems unsafe and call (407) 269-0453. Catching a problem early almost always means a smaller bill.

Garage Door Sensor Repair for Dundee Homes

On homes here that are 20 to 30 years old, sensor wiring is often the weak point. Insulation cracks, staples cut through wires, and connections corrode in the humid garage. We trace the run and replace damaged wire rather than just swapping the sensors.

Humidity causes condensation on sensor lenses and corrosion at the wire connections, and summer thunderstorms can send surges through the opener that damage sensors and the board. Spiders and insects also like to nest in sensor housings here. Wiping the lenses and checking the brackets every few months prevents a lot of service calls.

How Our Dundee Garage Door Sensor Repair Works

  1. Check the indicator lightsSensor LEDs tell us quickly whether the problem is alignment, power or a failed sensor.
  2. Inspect lenses and bracketsWe clean the lenses and straighten or replace bent brackets so the sensors line up.
  3. Test the wiringThe wire run back to the opener is checked for breaks, staples, corrosion and shorts.
  4. Repair or replaceWe realign, rewire or install new sensors matched to your opener.
  5. Run safety testsWe test the photo-eye reversal with an object in the doorway and check the opener’s contact reversal and force settings.

Why You Should Never Bypass Garage Door Sensors

It can be tempting to keep holding the wall button, or to tape the sensors together, just to get the door closed. That disables the system designed to keep the door from closing on a person, pet or car. A garage door is heavy enough to cause serious injuries.

If the door will not close and you need to leave, you can hold the wall button to close it once, while watching that the doorway is clear. Then call us. Sensor repairs are usually quick and inexpensive, and they put the safety system back in working order.

What Affects the Price of Garage Door Sensor Repair in Dundee

We quote a flat price after we inspect the door, so you know the full cost before we start. These are the things that move the price up or down:

  • Whether it is alignment, wiring or a failed sensor
  • Sensors matched to your opener’s brand
  • Length and condition of the wire run
  • Whether the opener’s logic board is also damaged
  • Sensor guards or relocation for sun or impact problems

You will never get a surprise add-on at the end of the job. If we find something else worn out, we show you and price it separately so you can decide.

Other Garage Door Services in Dundee

One call covers the whole door. These are the other services our Dundee technicians handle:

Dundee Garage Door Repair

Doors that stick, grind, reverse or will not move at all.

Dundee Garage Door Spring Replacement

Torsion and extension springs replaced same day, sized to your door.

Dundee Garage Door Opener Installation & Repair

Opener repair, replacement and remote programming, done right the first time.

Dundee Broken Cable Repair

Snapped or frayed lift cables replaced and crooked doors leveled.

Dundee Garage Door Installation

New wind-rated garage doors installed, old door hauled away.

Dundee Garage Door Panel Replacement

Dented, cracked and rusted sections replaced and color-matched.

Dundee Garage Door Roller Replacement

Worn rollers swapped for quiet nylon rollers.

Dundee Emergency Garage Door Repair

24/7 help for doors stuck open, stuck shut or off track.

Dundee Garage Door Maintenance & Tune-Up Service

Full inspection, balance, lube and safety test.

Garage Door Sensor Repair Near Dundee

We also provide sensor repair in the communities around Dundee:

See every city we cover on our areas we serve page, or read more about our Garage Door Sensor Repair service.

Dundee Garage Door Sensor Repair FAQs

Are garage door sensors required?

Openers sold in the U.S. have been required to include entrapment protection such as photo-eye sensors since the early 1990s. They should never be disabled.

How high should garage door sensors be mounted?

Usually no more than about six inches above the floor, on each side of the door, facing each other. That height keeps them low enough to detect a child or pet.

Why does one sensor light blink?

A blinking or off light usually means the sensors cannot see each other because of misalignment, a blocked lens or a wiring issue. On many openers, a solid light on both sides means they are aligned.

Why won’t my garage door close all the way?

The most common cause is the safety sensors. They may be out of alignment, dirty, blocked, in direct sun, or have a wiring problem. A misadjusted close limit or a binding door can also stop it.

How much does sensor repair cost?

Alignment and cleaning cost very little. New sensors or rewiring cost more, but still far less than most other garage door repairs. We give you a flat price before starting.

Book Dundee Garage Door Sensor Repair Today

Same-day service, flat-rate pricing and a two-hour arrival window across Dundee and Polk County.



Door stuck, loud or off its track?

Talk to a local dispatcher, get a flat-rate price, and pick a two-hour arrival window. 24/7 emergency response across Greater Orlando.

Call Now!(407) 269-0453 Book OnlinePick your window